List of top Electrical Engineering Questions

What is the frequency range for a headphone as a detector?
For a single frequency value, the most sensitive detector is:
In eddy current damping, the disc of an instrument is made of a material that is:
In general, fluid friction damping is not employed in indicating instruments although one can find its use in:
The pointer of an indicating instrument is generally made of:
The characteristic equation of a system is given by, \[ s^5 + 10s^3 + 5s^2 + 2 = 0 \] This system is:
Consider the following statements:
A system is said to be stable if its output is bounded for any input.
A system is stable if all the roots of the characteristic equation lie in the right half of the s-plane.
A system is stable if all the roots of the characteristic equation have negative real parts.
A second order system is always stable for finite positive values of open loop gain. Which of the above statements are correct?
Which of the following effects in the system is NOT caused by negative feedback?
Which mechanism in control engineering implies an ability to measure the state by taking measurements at output?
The Servo motor differs from standard motor principally in that, it has:
State space analysis is applicable even if the initial conditions are:
Which technique gives quick transient and stability response?
An alternator having an induced emf of 1.6 p.u. is connected to an infinite bus of 1 p.u. If the busbar has reactance of 0.6 p.u. and alternator has reactance of 0.2 p.u., what is the maximum power that can be transferred?
Consider a feedback system with gain margin of about 30. At what point does the Nyquist plot cross the negative real axis?
Which of the following types of faults does a bus differential relay NOT effectively detect?
In a multi-machine interconnected power system, subsequent to a 3-phase fault, the transient stability is examined by:
In a 220kV system, the inductance and capacitance up to the circuit breaker location are 25 mH and 0.025 micro Farads. The value of the resistor required to be connected across the breaker contacts which will give no transient oscillations is:
The Y-bus matrix of a 100-bus interconnected system is 90% sparse. Hence the number of transmission lines in the system must be:
In a bode magnitude plot, which one of the following slopes would be exhibited at high frequencies by a 4th order all-pole system?
Which of the following circuit breakers take minimum time in installation?
Which of the following is not a requirement for site selection of a hydroelectric power plant?
Fault calculations using computer programs are usually done by:
Which component of gas turbine power plant is the main cause of its low efficiency?
A protection system engineer is planning to provide complete protection for a 3-phase transmission line. He can achieve this by:
For a given power system, its zero and maximum regulation will occur at the impedance angle of: