List of top Questions asked in CUET (PG)

A variate \(X\) has the probability distribution:
Arrange the following in increasing order:
A. \(E(X)\)
B. \(E(X^2)\)
C. \(E[(2X+1)^2]\)
D. \(\sigma^2\)
A problem in Mathematics is given to three students P, Q and R whose chances of solving it are \(\frac{1}{2}, \frac{1}{3}, \frac{1}{4}\) respectively. Arrange the following probabilities in decreasing order: A. The probability that P cannot solve the problem
B. The probability that Q cannot solve the problem
C. The probability that P, Q and R cannot solve the problem
D. The probability that the problem will be solved by at least one student Choose the correct answer:
Assertion (A): When a thin flat plate is held parallel to a fluid stream, both pressure drag as well as viscous drag will be negligible.
Reason (R): The total drag on the plate will be entirely due to shear stress and pressure drag will be negligible.
Assertion (A): In a power plant working on a Rankine cycle, the regenerative feed water heating improves the efficiency of the steam turbine.
Reason (R): The regenerative feed water heating raises the average temperature of heat addition in the Rankine cycle.
Assertion (A): In Electrical Discharge Machining (EDM), fragile parts can be machined without distortion because no mechanical work is involved.
Reason (R): The surface finish of the finished components made using EDM is poor because of presence of small craters.
Assertion (A): When a component is subjected to fluctuating stresses, Goodman line is more safe from design considerations.
Reason (R): Goodman line is completely inside the Gerber parabola and inside the failure points.
Assertion (A): Aluminium has poor weldability.
Reason (R): Aluminium has high thermal conductivity and high affinity to oxygen.
Assertion (A): Transmissibility is the ratio of force applied to the force transmitted.
Reason (R): Transmissibility is a measure of effectiveness of vibration isolating material.
Which task of vision systems recognize and classify an object?
Assertion (A): If \(P = \begin{bmatrix}1 & 4 \\ 2 & 3 \end{bmatrix}\), then \(P^2 - 4P - 5I = 0\).
Reason (R): Every square matrix satisfies its own characteristic equation.
Assertion (A): Any square matrix \(P\) and its transpose \(P^T\) have the same eigen values.
Reason (R): The eigen values of an idempotent matrix are either zero or unity.
How many degree of freedom is possessed by a manipulator link free in a 3-D space?
In a CNC machine tool, encoder is used to sense and control:
Which type of robot possesses two revolute and one prismatic joint?
When a control signal is generated proportional to rate of change of position error, the controller is:
In sensors, the response time is the time required:
The tactile sensor is used to measure:
In a machining operation, doubling the cutting speed reduces the tool life to \(\frac{1}{8}\) of the original value. The exponent ‘n’ in Taylor’s tool life equation \(VT^n = C\) is:
Two identical circular rods of same diameter and length are subjected to same axial tensile force. One is mild steel and other aluminium. Which is correct?
The lead time is defined as:
Tolerances are specified in manufacturing parts:
Green sand mould indicates that:
The difference between dry bulb temperature and wet bulb temperature is called:
A petrol engine has compression ratio from:
If a body is at 1727°C, the wavelength at which the body emits maximum radiation is: