>
CUET (PG) 2026
List of top Questions asked in CUET (PG)- 2026
Assertion (A): Gallium arsenide is a direct band semiconductor having faster switching capabilities and high temperature operating capabilities. Reason (R): A substance for which the forbidden energy region is relatively small is called a semiconductor.
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Electronic devices
Which of the following theorems are used to simplify a linear circuit into an equivalent form with a single source and impedance? A. Thevenin's theorem B. Norton's theorem C. Superposition theorem D. Reciprocity theorem
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Network Theory
Carson’s rule for estimating the bandwidth (B) of an FM signal is:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
communication systems
Assertion (A): 8-bit PCM system performs better than 4-bit PCM system. Reason (R): 8-bit system produces smaller quantization noise than 4-bit system.
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
communication systems
The steady-state error of a Type 1 system for a unit step input is:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Control Systems
Which of the following are listed as types of compensators for system design? A. Lead compensators B. Stepper motors C. Lag compensators D. Servo valves
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Control Systems
Assertion (A): A network in which circuit elements like resistance, inductance and capacitance cannot be physically separated or analysis purpose is called lumped network. Reason (R): Most of the electric network are lumped in nature.
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Network Theory
Assertion (A): The ability of a differential amplifier to reject a differential mode signal is called its figure of merit. Reason (R): The ideal value of figure of merit of a differential amplifier is infinite.
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Amplifiers
For maximum power transfer in an AC circuit, the load impedance $Z_L$ should be:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Circuit Analysis
The noise at the input of an ideal frequency detector is white, the power spectral density of the noise at the output is:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
communication systems
For an Op-amp, CMRR = $10^5$ and differential gain = $10^6$, what is the common mode gain of the Op-amp?
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Op-Amp and Its Applications
The signal $x(t) = A\cos(\omega t + \phi)$ is:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Signals and Systems
Assertion (A): FET is a majority carrier device whereas BJT works based on movement of both majority and minority carriers. Reason (R): Thermal runaway occurs in FET circuits but does not occur in BJT circuits.
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Transistors
In a Quadrature Amplitude Modulation (QAM) scheme, information is encoded in:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
communication systems
According to Nyquist stability criterion, the number of unstable closed-loop poles (Z) is equal to:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Control Systems
Assertion (A): Feedback control systems offer more accurate control over open-loop systems. Reason (R): Feedback establishes a link for input-output comparison and correction.
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Control Systems
If a fair coin is tossed 4 times, what is the probability that two heads and two tails will result?
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Calculus
A source generates symbols with probabilities (0.5, 0.25, 0.25) at a rate of 300 symbols per second. The most efficient source encoder would have average bit rate:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
communication systems
Which of the following theorems from calculus relate an integral over a region to an integral over its boundary? A. Stoke’s theorem B. Gauss’s divergence theorem C. Mean value theorem D. Taylor series
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Vector Calculus
The Nyquist sampling theorem states that for a signal with maximum frequency $f_m$, the sampling frequency must be:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Signals and Systems
Arrange correct sequence of time domain specifications of a second order system in ascending order of values: A. Rise time B. Settling time C. Delay time D. Peak time
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Control Systems
Port 80 is used for:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
communication systems
Which of the following are fundamental concepts from Shannon's information theory? A. Entropy B. Matched filter receiver C. Auto correlation D. Channel capacity theorem
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
communication systems
A Zener diode is primarily used for:
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Zener Diodes
Assertion (A): With lag-lead compensator, the bandwidth of the system is not affected much. Reason (R): The effect of lag and lead compensation at high frequencies cancel one another.
CUET (PG) - 2026
CUET (PG)
Electronics and Communication Engineering
Control Systems
Prev
1
...
202
203
204
205
206
...
298
Next