List of top Questions asked in AP ECET Agricultural Engg- 2025

An iron or brass ring fitted at the bottom of the sickle handle to prevent it from splitting during the operation

Process of joining permanently two pieces of sheet metal without any heat energy is known as

In arc welding, the arc is created between the electrode and

Process of cutting internal threads in a metal by using a hand tool is known as

The percentage of carbon dioxide in the atmosphere is____ppm

The longest of the chain lines used in making survey is generally called as

The unit of a lathe which houses the lathe spindle and control levers for speed selection is called a

The device used to hold round material of small diameter such as wire and pins is

The length of revenue chain is

In the method of surveying the field work and plotting are done simultaneously is called

Zinc-coated iron sheet is known as

The rod staff level reading taken on a point of known elevation is called

The perpendicular distance between the lines of action of the two equal and opposite parallel forces, is known as

Lysimeter is used to measure

Zeroth law of thermodynamics is concerned with

The ratio of stress to strain for any given material is called

Plantation of high water consuming trees for withdrawal of groundwater is termed as

It is provided as a safety measure against overtopping of channels due to wave action or other unforeseen reasons is

The tooth spacing in a saw is called

In an ideal thermodynamic cycle for compression-ignition (engines) heat is added at

The equipment used to establish in-situ drainage in the fields

The weir, which commonly used to measure minimum discharges in open channels

The permanent irrigation channels should not usually have side slopes steeper than

Piezometer is used to measure

Contour bunding is used_____