List of top Questions asked in TS PGECET- 2026

In Spinning Triangle the height is ZERO, it indicates
Use of Air Nozzle in Ring Frame results in
Consider the following and choose the correct answer with respect to Twisting of yarn. Assertion [A]: Ring rail moves fast in one direction and slow in other direction. Reason [R]: Yarn Balance is obtained by winding and binding coils
In Carding, Point to Point action occurs between
In Comber preparatory, as the Pre-Comb draft increases, the Noil % will
In Modern Comber, use of half moon shaped Web it is possible to achieve Combed Sliver with
In Roving frame, the Sliver Breakage stop motion is based on one of the following principles
Long Trunk is observed in
In which of the following, number of teeth decides the Noil % in Comber
The production of Trilobal fibre in Man-made fibre is derived from the feature of
Tinting is done in one of the following cases
The drive for the feed lattice in Mixing Bale Opener is
It is a quality control study (Routine), in which the examination is in three areas across the width of output in Carding
A Control fabric has Numeri 6, after mercerization the expected value is
The constant used for conversion from Denier to Cotton system is
In fibre length analysis, Dispersion or Scatter is useful to determine
Match the following:
Spinning speeds in Man-made fibre of \(10,000\ \text{mpm}\) results in the formation of which Yarn?
In a Blowroom, a study was made to compare the fibre fracture using 2 Bladed and Kirschner beater. When the same mixing was processed using two Blowroom lines, the best statistical measure to choose is
Mercerisation of Cotton fabrics will result in
Consider Shirting fabrics made from Varalakshmi Cotton and 14 tex Polyester Texturised yarns, then the bending rigidity of Polyester fabric when compared to Cotton is
The common type of Staple fibre produced during synthetic fibre manufacture is
In which type of cotton production, fertilizers are not used?
\(TiO_{2}\) is used as an agent in manufacturing synthetic fibre for
What method is commonly used for the estimation of the percentage of Spin finish?