List of top Metallurgical Engineering Questions

Stainless steel is welded using
A casting defect, which occurs near the ingates as rough lumps on the surface of a casting is known as
Skim bob is attached to
Die casting of aluminium is not done because of the reason that, it is
Which of the following is \textbf{not a non-destructive test?}
In two high reversing mill, the rolls used are
Forging is accomplished in drop forging by dropping the
The microsegregation observed in casting is called
Which of the following is an exclusively cold working process?
Hot extrusion of aluminium is done in the temperature range of
In cold working of steel
Strain ageing is common in
Which of the following has the lowest tensile strength?
Which of the following occupy maximum percentage of powder metallurgy parts distribution in the engineering industry?
Which of the following assumptions is not related to continuous casting?
The objection with the use of ------------- is a tendency for producing a fountain effect in the casting.
The most serious manufacturing defect from fracture toughness point of view is
Movement of jogs can produce
Frank–Read source
The primary strengthening mechanism in 70:30 brass is
Stress intensity factor, \( K_{\text{IC}} \), not depends on
The tensile load-elongation curve of a metal does not describe
Von Mises criterion for plastic yielding of a ductile material predicts that the yield stress in uniaxial tension is related to that in pure torsion as
Stretcher strains found in a low carbon sheet are associated with
Which of the following mechanical properties of a material is most structure insensitive?