List of top Civil Engineering Questions asked in AP PGECET

Identify the roller best suitable for compaction of cohesionless soils.
The test performed on pile to separate load capacity into skin friction and end bearing components is _____.
The grade of concrete used for pre-stressed concrete shall not be less than _____.
Normally, the tensile strength of concrete is about ______ of its compressive strength.
The section in which concrete is not fully stressed to its maximum permissible value while stress in steel reaches its maximum value is called ____
Maximum longitudinal reinforcement in columns shall not exceed ____
The analysis of slab spanning in one direction is done by assuming it to be a beam of
The minimum water content at which soil is fully saturated is ____
What type of stresses are artificially induced by prestressed concrete in a structure before it is loaded?
The Indian Standard Soil classification symbol for low compressible inorganic silt is ____
Permeability of soil:
For production of structural elements, which of the following system is used?
A reinforced slab built monolithically with the supporting columns and is reinforced in two or more directions, without any provision of beams, is called a____
Name the field test to evaluate sensitivity of soft clay:
The mineral responsible for swelling of black cotton soil is ____
Lateral ties in reinforced concrete columns are provided to resist ____
The slenderness ratio of single angle single bolted strut should be less than ____
A steel column in a multi-storied structure carries a load of \(125\,\mathrm{kN}\). It is built up of 2 ISMC 350 channels connected by lacing. The lacing is designed for load of ____
Load on connection is not eccentric for ____
The neutral axis of the reinforced beam passes through ____
Flow duration curve is a plot of ____
If \(v=3xy\), the magnitude of the velocity vector at \((2,-2)\) is ____
The minor losses due to sudden contraction is significantly attributed to ____
An oil of kinematic viscosity \(0.4\) stokes flows through a pipe of diameter \(10\) cm. The flow may not be essentially laminar at a velocity of ____
Contours of different elevations may cross each other only in the case of ____