List of top Questions asked in AP ECET Agricultural Engg

The component designed to take side thrust from soil in MB plough is
A plough which can enter up to 60-90 cm without disturbing top soil and also useful in moisture conservation in rain-fed areas is
The tillage system in which, a crop is planted directly into a untilled seedbed after harvesting of the previous crop is known as
The discharge of emitter usually ranges from {
The vertical distance between the water surface at the source and at the outlet in a pumping system is
Rolling plough bottom exists in the following
In sprayer____is used
The velocity of water in a stream or river can be measured by
Land leveling is not essential for {
Drop spillway is adopted up to {
The removal of a fairly uniform layer of soil from the land surface by the action of rainfall and runoff is known as
Revised universal soil loss equation (RUSLE) has been developed for allowing more detail consideration of
The property of moulding sand which enable to allow the escape of the gases from the mould is
To determine the elevation difference between two points far apart (e.g., across a river) and is impossible to set up the instrument in between, {
Least count of Theodolite is
The total depth of water needed for a crop during its base period is known as
The head quarter of Central soil and water Conservation Research and Training Institute is situated at
Establishment of intermediate points in between main stations for accurate straight line measurement in chain survey is known as
The device used for stepping up low voltage of primary current to high voltage current in petrol engine is
Fan-and Pad cooling system today it is commonly made of a
Kilo watt-hour(kWh) is the unit of
In a semiconductor, conductivity can be increased by
A compact hand instrument used in setting out right angles with greater accuracy is known as
The proportion of wet cow dung and water in slurry feed to the digester is
Ethanol preferred as fuel due to its cetane number is