Question:
Under ideal conditions in drawing operation maximum possible reduction of area in one pass is:
Under ideal conditions in drawing operation maximum possible reduction of area in one pass is:
Show Hint
In drawing the maximum reduction of area is an important factor influencing the successful shaping of the material typically achieving up to 63%
Updated On: Jan 17, 2026
- 28%
- 47%
- 63%
- 71%
Show Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
In drawing the maximum possible reduction of area in one pass is theoretically limited by the material properties The maximum reduction of area is generally accepted as 63%
Was this answer helpful?
0
0
Top CUET PG Mechanical Engineering Questions
- The vacuum in a closed container is 50 mm of Hg The absolute pressure in the container is
- Consider the following statements: The assumptions made in deriving Euler’s equation are:
- Fluid is non-viscous fluid.
- The flow is along a streak line.
- Match List I (Non-dimensional number) with List II (It is the ratio of):Choose the correct answer from the options given below:
LIST I LIST II A. Reynold’s Number III. Inertia force to viscous force B. Mach Number I. Inertia force to elastic force C. Froude’s Number II. Inertia force to gravity force D. Weber’s Number IV. Inertia force to surface tension force - Given below are two statements:
Statement (A): The flow in a pipe is turbulent when the Reynolds’ Number is more than 4000.
Statement (R): The flow in a pipe is turbulent at entry and slowly changes to laminar along the length of the pipe.
In light of the above statements, choose the correct answer from the options given below: - Consider the following statements about the flow in a convergent-divergent nozzle operating under design conditions:
- In the divergent section, pressure is higher than the pressure in the convergent section.
- The pressure at the throat is equal to critical pressure.
- The pressure in the convergent section reduces.
- The flow is subsonic in the convergent section and supersonic in the divergent section.
View More Questions
Top CUET PG Casting, Forming and Joining Processes Questions
- Centre-line feeding resistance CFR indicates the difficulty of feeding a given alloy in a mould Normally feeding is considered to be difficult if
- The DC power source for arc welding has the characteristics \( 3V + I = 240 \), where 'V' is the voltage in volts and 'I' is the current in amperes. For maximum power at the electrode, voltage should be set at:
- Which of the following is a solid state joining process?
Top CUET PG Questions
- Given below are two statements:
Statement I: For Plato the meaning of the word 'Justice' is basically a conception in the mind only.
Statement II: For Plato the meaning of the word 'Justice' is fixed, mind-independently
In the light of the above statements, choose the correct answer from the options given below: - What is the electron count of OS6CO182-?
- XeF4 hydrolysis gives A + B, HF, and Oxygen. Find A and B
- What is more basic in pyrol and pyridine?
- Hydrolysis of Al2C3, Be2?
View More Questions