Question:
The tooth spacing in a saw is called
The tooth spacing in a saw is called
Show Hint
High Pitch = Fewer teeth = Faster, rougher cut. Low Pitch = More teeth = Slower, smoother cut.
Updated On: May 5, 2026
- Saw width
- Pitch
- Tooth back
- Tooth gullet
Show Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
Step 1: Concept
Saw blades are characterized by several geometric parameters defining the size and shape of the teeth.
Step 2: Meaning
The spacing determines how aggressive the cut will be and how much material is removed.
Step 3: Analysis
Pitch is defined as the distance between the tips of two adjacent teeth. It is often expressed as "teeth per inch" (TPI). The gullet is the space between teeth where sawdust is carried.
Step 4: Conclusion
The spacing is called the pitch.
Final Answer: (B)
Was this answer helpful?
0
0
Top AP ECET Agricultural Engg Agricultural Engineering Questions
- Which of the following equipment is used for the determination of specific gravity of granular agricultural materials?
- In pneumatic conveying and separation processes, the material is lifted only when the air velocity is greater than its
- The friction forces existing between the surfaces in relative motion is known as
- The Newton's law of viscosity and a simple dashpot represent rheological model for
- The ability of a screen in closely separating the feed into overflow and underflow according to its size is known as
View More Questions
Top AP ECET Agricultural Engg Irrigation and Drainage Questions
- The purpose of free board in canal is to
- The weir, which commonly used to measure medium discharges is
- The diameter of opening in Orifices ranges from
- The water measuring device which does not get clogged due to suspended silt or floating debris during measurement is
- The permanent irrigation channels should not usually have side slopes steeper than
View More Questions
Top AP ECET Agricultural Engg Questions
- Which of the following equipment is used for the determination of specific gravity of granular agricultural materials?
- In pneumatic conveying and separation processes, the material is lifted only when the air velocity is greater than its
- The friction forces existing between the surfaces in relative motion is known as
- The Newton's law of viscosity and a simple dashpot represent rheological model for
- The ability of a screen in closely separating the feed into overflow and underflow according to its size is known as
View More Questions