Question:
The primary function of a clamper circuit is
The primary function of a clamper circuit is
Show Hint
Clampers are useful for modifying waveforms by adding a DC bias, which can help in applications where a fixed DC level is needed for an AC signal.
Updated On: May 5, 2025
- Suppress variations in signal voltage
- Raise the positive cycle of the signal
- Lower the negative cycle of the signal
- Introduce a DC level to an AC signal
Show Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
The main function of a **clamper circuit** is to add or subtract a DC level from an AC signal, thus "clamping" the signal to a specified voltage. This allows the waveform to be shifted vertically, either above or below the baseline. Therefore, the correct answer is option (4).
Was this answer helpful?
0
0
Top AP PGECET Electronics and Communication Engineering Questions
- Identify the Y equivalent of a network of the circuit shown in Figure below.
- The mesh current method
(I) Works with both planar and non-planar circuits
(II) Uses Kirchhoff’s voltage law
Which of the above is correct? - If there are 5 branches and 4 nodes in the graph, then the number of mesh equations that can be formed are?
- The current waveform \(i(t)\) in a pure resistor of 20 \( \Omega \) is as shown in the figure below, then the power dissipated in the resistor is
- In the following figure, \(C_1\) and \(C_2\) are ideal capacitors. \(C_1\) has been charged to 12V before the ideal switch \(S\) is closed at \(t = 0\). The current \(i(t)\) for all \(t\) is
View More Questions
Top AP PGECET Digital Signal Processing Questions
- A circuit that uses an amplifier with passive filter elements is called as a(n)
- If the input to a comparator is a sine wave, the output is
- What is the period of the following signal, \( x(t) = \sin(18\pi t + 78^\circ) \)?
- A PAM signal can be detected by using
- A function \( x(t) \) is said to have half-wave odd symmetry if
View More Questions
Top AP PGECET Questions
- If 125V is applied across a 250V, 100W incandescent bulb, the power consumed will be _____ .
- The power consumed by a coil is 300 watts when connected to a 30V DC source and 108 watts when connected to a 30V AC source. The reactance of the coil is ____ .
The supply voltage magnitude \( |V| \) of the circuit shown below is ____ .
A two-port network is defined by the relation
\(\text{I}_1 = 5V_1 + 3V_2 \)
\(\text{I}_2 = 2V_1 - 7V_2 \)
The value of \( Z_{12} \) is:- Which of the following theorems is the dual of Norton’s theorem?
View More Questions