Question:
A circuit that uses an amplifier with passive filter elements is called as a(n)
A circuit that uses an amplifier with passive filter elements is called as a(n)
Show Hint
In signal processing, active filters are often used when amplifiers are combined with passive components to control frequency response.
Updated On: May 5, 2025
- Relaxation oscillator
- Signal generator
- Differential amplifier
- Active filter
Show Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
A circuit that uses an amplifier along with passive filter elements (such as resistors, capacitors, and inductors) is called an **active filter**. Active filters use amplifiers to enhance the filtering capability, often used to process analog signals and remove unwanted frequencies. Therefore, the correct answer is option (4).
Was this answer helpful?
0
0
Top AP PGECET Electronics and Communication Engineering Questions
- Identify the Y equivalent of a network of the circuit shown in Figure below.
- The mesh current method
(I) Works with both planar and non-planar circuits
(II) Uses Kirchhoff’s voltage law
Which of the above is correct? - If there are 5 branches and 4 nodes in the graph, then the number of mesh equations that can be formed are?
- The current waveform \(i(t)\) in a pure resistor of 20 \( \Omega \) is as shown in the figure below, then the power dissipated in the resistor is
- In the following figure, \(C_1\) and \(C_2\) are ideal capacitors. \(C_1\) has been charged to 12V before the ideal switch \(S\) is closed at \(t = 0\). The current \(i(t)\) for all \(t\) is
View More Questions
Top AP PGECET Digital Signal Processing Questions
- If the input to a comparator is a sine wave, the output is
- The primary function of a clamper circuit is
- What is the period of the following signal, \( x(t) = \sin(18\pi t + 78^\circ) \)?
- A PAM signal can be detected by using
- A function \( x(t) \) is said to have half-wave odd symmetry if
View More Questions
Top AP PGECET Questions
- If 125V is applied across a 250V, 100W incandescent bulb, the power consumed will be _____ .
- The power consumed by a coil is 300 watts when connected to a 30V DC source and 108 watts when connected to a 30V AC source. The reactance of the coil is ____ .
The supply voltage magnitude \( |V| \) of the circuit shown below is ____ .
A two-port network is defined by the relation
\(\text{I}_1 = 5V_1 + 3V_2 \)
\(\text{I}_2 = 2V_1 - 7V_2 \)
The value of \( Z_{12} \) is:- Which of the following theorems is the dual of Norton’s theorem?
View More Questions