Question:
Interparticle forces present in nylon-66 are:
Interparticle forces present in nylon-66 are:
Show Hint
Hydrogen bonding increases polymer strength.
Updated On: Mar 17, 2026
- van der Waals’
- hydrogen bonding
- dipole–dipole interactions
- None of the above
Show Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
Nylon-66 contains –NH– and –CO– groups which form strong intermolecular hydrogen bonds.
Was this answer helpful?
0
0
Top BITSAT Chemistry Questions
- Which of the following silver salts is insoluble in water ?
- Which of the following is deliquescent ?
- Among the following sets of quantum numbers. Which one is incorrect for $4d$ electron ?
- In the purification of impure nickel by Mond's process, metal is purified by:
- When $25\, g$ of a non-volatile solute is dissolved in $100\,g$ of water, the vapour pressure is lowered by $2.25 \times 10^{-1}\, mm$. If the vapour pressure of water at $20^{\circ} C$ is $17.5\, mm$, what is the molecular weight of the solute?
View More Questions
Top BITSAT Polymers Questions
- Polymer used in bullet proof glass is
- Formation of polyethylene from calcium carbide takes place as follows: CaC₂ + 2H₂O → Ca(OH)₂ + C₂H₂ C₂H₂ + H₂ → C₂H₄ nC₂H₄ → (–CH₂–CH₂–)ₙ The amount of polyethylene obtained from 64.1kg of CaC₂ is:
- Polymer used in bullet proof glass is
- Which of the following can be repeatedly softened on heating? (i) Polystyrene (ii) Melamine (iii) Polyesters (iv) Polyethylene (v) Neoprene
- Formation of polyethylene from calcium carbide takes place as follows: beginaligned CaC₂ + 2H₂O &→ Ca(OH)₂ + C₂H₂
C₂H₂ + H₂ &→ C₂H₄
nC₂H₄ &→ (-CH₂-CH₂-)ₙ endaligned The amount of polyethylene obtained from 64.1kg of CaC₂ is:
View More Questions
Top BITSAT Questions
- Two point charges $-q$ and $+ q$ are located at point's $(0, 0, - a)$ and, $(0, 0, a)$ respectively. The electric potential at a point $(0, 9, z)$, where $z > a$ is
- Which of the following must be known in order to determine the power output of an automobile?
- A large drop of oil (density $0.8 \,g / cm ^{3}$ and viscosity $\eta_{0}$ ) floats up through a column of another liquid (density $1.2\, g / cm ^{3}$ and viscosity $\eta_{L}$ ). Assuming that the two liquids do not mix, the velocity with which the oil drop rises will depend on :
- A body is projected vertically upwards at time $ t = 0$ and it is seen at a height $H$ at time $t_1$ and $t_2$ second during its flight. The maximum height attained is ($g$ is acceleration due to gravity)
- At what point of a projectile motion, acceleration and velocity are perpendicular to each other ?
View More Questions