Question:
In QAM, both ______ of a carrier frequency are varied.
In QAM, both ______ of a carrier frequency are varied.
Show Hint
QAM is widely used in digital communication systems such as cable modems, satellite TV, and wireless networks to transmit high data rates.
Updated On: May 5, 2025
- Frequency and amplitude
- Phase and frequency
- Amplitude and phase
- Differential amplitude
Show Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
In Quadrature Amplitude Modulation (QAM), both the amplitude and phase of the carrier signal are varied. This technique combines amplitude modulation (AM) and phase modulation (PM) to increase the data rate over a given bandwidth.
Was this answer helpful?
0
0
Top AP PGECET Electronics and Communication Engineering Questions
- Identify the Y equivalent of a network of the circuit shown in Figure below.
- The mesh current method
(I) Works with both planar and non-planar circuits
(II) Uses Kirchhoff’s voltage law
Which of the above is correct? - If there are 5 branches and 4 nodes in the graph, then the number of mesh equations that can be formed are?
- The current waveform \(i(t)\) in a pure resistor of 20 \( \Omega \) is as shown in the figure below, then the power dissipated in the resistor is
- In the following figure, \(C_1\) and \(C_2\) are ideal capacitors. \(C_1\) has been charged to 12V before the ideal switch \(S\) is closed at \(t = 0\). The current \(i(t)\) for all \(t\) is
View More Questions
Top AP PGECET communication systems Questions
- If the highest modulation frequency is 5 kHz, find out bandwidth.
- In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately equal to
- At a given probability of error, binary coherent FSK is inferior to binary coherent PSK by
- Which of the following analog modulation schemes requires the minimum transmitted power and minimum channel bandwidth?
- For a modulation index much less than 1, the FM signal is considered as
View More Questions
Top AP PGECET Questions
- If 125V is applied across a 250V, 100W incandescent bulb, the power consumed will be _____ .
- The power consumed by a coil is 300 watts when connected to a 30V DC source and 108 watts when connected to a 30V AC source. The reactance of the coil is ____ .
The supply voltage magnitude \( |V| \) of the circuit shown below is ____ .
A two-port network is defined by the relation
\(\text{I}_1 = 5V_1 + 3V_2 \)
\(\text{I}_2 = 2V_1 - 7V_2 \)
The value of \( Z_{12} \) is:- Which of the following theorems is the dual of Norton’s theorem?
View More Questions