Current measured by the ammeter Ⓐ in the reported circuit when no current flows through 10 Ω resistance, will be ___ A.
Fig. Circuit
Current measured by the ammeter Ⓐ in the reported circuit when no current flows through 10 Ω resistance, will be ___ A.
Correct Answer: 10
Solution and Explanation
The correct answer is 10
By using the condition of a balanced wheat stone bridge, we get
\(⇒ \frac{R}{3} =\frac{4}{6} ⇒ 2Ω\)
Therefore , the effective resistance of the circuit is
\(R_{eq} = \frac{6×9}{6+9} = \frac{18}{5} Ω\)
\(i = \frac{36}{R_{eq}} = 10 A\)
Top JEE Main Physics Questions
- 1 mole of ideal diatomic gas is enclosed in a cylinder piston arrangement having cross-sectional area of piston \(4\,\text{cm}^2\). If gas has only rotational modes and \(P_{atm}=100\ \text{kPa}\), some amount of heat is added to the system as a result piston moves up slowly by \(2.5\,\text{cm}\). If temperature change is \(1.2^\circ C\). Find heat given to gas.
- JEE Main - 2026
- Physics
- Thermal Physics
Refer the figure below. \( \mu_1 \) and \( \mu_2 \) are refractive indices of air and lens material respectively. The height of image will be _____ cm.
- JEE Main - 2026
- Physics
- Optics and Refraction
In single slit diffraction pattern, the wavelength of light used is \(628\) nm and slit width is \(0.2\) mm. The angular width of central maximum is \(\alpha \times 10^{-2}\) degrees. The value of \(\alpha\) is ____.
- JEE Main - 2026
- Physics
- Interference and Diffraction
- If X and Y are the inputs, the given circuit works as _______.
- JEE Main - 2026
- Physics
- Digital Circuits
If a body of mass 1 kg falls on the earth from infinity, it attains velocity \( v \) and kinetic energy \( k \) on reaching the surface of the earth. The values of \( v \) and \( k \) respectively are _______.
- JEE Main - 2026
- Physics
- Gravitation
Top JEE Main Current electricity Questions
- Refer to the circuit diagram given below. The heat generated across the $6\ \Omega$ resistance in 100 second is $\frac{\alpha}{100}\ J$. The value of $\alpha$ is ________. (Nearest integer)
- JEE Main - 2026
- Physics
- Current electricity
- The maximum rated power of the LED is $2 \text{ mW}$ and it is used in the circuit with input voltage of $5 \text{ V}$ as shown in the figure below. The current through resistance $R$ is $0.5 \text{ mA}$. The minimum value of the resistance $R_s$, to ensure that the LED is not damaged is ______ $\text{k}\Omega$.
In the provided circuit, the input voltage is $5 \text{ V}$, a series resistor $R_s$ is connected, and the circuit then branches into two parallel paths: one with a resistor $R = 1 \text{ k}\Omega$ in series with a Zener diode, and another with the LED.
- JEE Main - 2026
- Physics
- Current electricity
- Find charge on capacitor at steady state.
- JEE Main - 2026
- Physics
- Current electricity
- In an RLC series circuit the value of \(R, L\) and \(C\) is given as \(R = 50\Omega\), \(L = 1.6\,H\) and \(C = 40\mu F\). Find the value inductive reactance \((X_L)\) at resonance.
- JEE Main - 2026
- Physics
- Current electricity
- Find the voltage \(V_{AB}\) and the current \(i_{BA}\) in the given circuit.
- JEE Main - 2026
- Physics
- Current electricity
Top JEE Main Questions
- 1 mole of ideal diatomic gas is enclosed in a cylinder piston arrangement having cross-sectional area of piston \(4\,\text{cm}^2\). If gas has only rotational modes and \(P_{atm}=100\ \text{kPa}\), some amount of heat is added to the system as a result piston moves up slowly by \(2.5\,\text{cm}\). If temperature change is \(1.2^\circ C\). Find heat given to gas.
- JEE Main - 2026
- Thermal Physics
- Let $S = \{\theta \in (-2\pi, 2\pi) : \cos\theta + 1 = \sqrt{3} \sin\theta\}$. Then $\sum_{\theta \in S} \theta$ is equal to:
- JEE Main - 2026
- Trigonometry
Refer the figure below. \( \mu_1 \) and \( \mu_2 \) are refractive indices of air and lens material respectively. The height of image will be _____ cm.
- JEE Main - 2026
- Optics and Refraction
In single slit diffraction pattern, the wavelength of light used is \(628\) nm and slit width is \(0.2\) mm. The angular width of central maximum is \(\alpha \times 10^{-2}\) degrees. The value of \(\alpha\) is ____.
- JEE Main - 2026
- Interference and Diffraction
\(t_{100\%}\) is the time required for 100% completion of a reaction, while \(t_{1/2}\) is the time required for 50% completion of the reaction. Which of the following correctly represents the relation between \(t_{100\%}\) and \(t_{1/2}\) for zero order and first order reactions respectively
- JEE Main - 2026
- Zero-order Reactions
Concepts Used:
Current Electricity
Current electricity is defined as the flow of electrons from one section of the circuit to another.
Types of Current Electricity
There are two types of current electricity as follows:
Direct Current
The current electricity whose direction remains the same is known as direct current. Direct current is defined by the constant flow of electrons from a region of high electron density to a region of low electron density. DC is used in many household appliances and applications that involve a battery.
Alternating Current
The current electricity that is bidirectional and keeps changing the direction of the charge flow is known as alternating current. The bi-directionality is caused by a sinusoidally varying current and voltage that reverses directions, creating a periodic back-and-forth motion for the current. The electrical outlets at our homes and industries are supplied with alternating current.