Question:
The vertical distance between the water surface at the source and at the outlet in a pumping system is
The vertical distance between the water surface at the source and at the outlet in a pumping system is
Show Hint
Total Static Head = (Height from water to pump) + (Height from pump to tank).
Updated On: May 5, 2026
- Static suction Head
- Static discharge head
- Static velocity head
- Total static head
Show Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
Step 1: Concept
Head is the measure of pressure or height that a pump must overcome to move water.
Step 2: Meaning
Static head refers to the purely vertical distance, ignoring friction or velocity effects.
Step 3: Analysis
Static suction head is from the source to the pump. Static discharge head is from the pump to the outlet. The sum of these two, which represents the total vertical rise from source to outlet, is the total static head.
Step 4: Conclusion
This total distance is defined as the total static head.
Final Answer: (D)
Was this answer helpful?
0
0
Top AP ECET Agricultural Engg Agricultural Engineering Questions
- Which of the following equipment is used for the determination of specific gravity of granular agricultural materials?
- In pneumatic conveying and separation processes, the material is lifted only when the air velocity is greater than its
- The friction forces existing between the surfaces in relative motion is known as
- The Newton's law of viscosity and a simple dashpot represent rheological model for
- The ability of a screen in closely separating the feed into overflow and underflow according to its size is known as
View More Questions
Top AP ECET Agricultural Engg Farm Machinery and Power Engineering Questions
- Which of the following equipment/machinery best suited for puddling operation in paddy?
- The tillage system in which, a crop is planted directly into a untilled seedbed after harvesting of the previous crop is known as
- The size of light duty animal drawn mouldboard plough is
- The edge of the share which forms joint between mould board and the share on the frog is known as
- The device to make lateral adjustment of the plough relative to the line of pull is known as
View More Questions
Top AP ECET Agricultural Engg Questions
- Which of the following equipment is used for the determination of specific gravity of granular agricultural materials?
- In pneumatic conveying and separation processes, the material is lifted only when the air velocity is greater than its
- The friction forces existing between the surfaces in relative motion is known as
- The Newton's law of viscosity and a simple dashpot represent rheological model for
- The ability of a screen in closely separating the feed into overflow and underflow according to its size is known as
View More Questions