Two charges \( +q \) and \( -q \) are placed at points \( A \) and \( B \) respectively which are at a distance \( 2L \) apart. \( C \) is the midpoint of \( AB \). The work done in moving a charge \( +Q \) along the semicircle CSD (\( W_1 \)) and along the line CBD (\( W_2 \)) are 
Find work done in bringing charge q = 3nC from infinity to point A as shown in the figure : 
What are the charges stored in the \( 1\,\mu\text{F} \) and \( 2\,\mu\text{F} \) capacitors in the circuit once current becomes steady? 
Which one among the following compounds will most readily be dehydrated under acidic condition?

Manufacturers supply a zener diode with zener voltage \( V_z=5.6\,\text{V} \) and maximum power dissipation \( P_{\max}=\frac14\,\text{W} \). This zener diode is used in the circuit shown. Calculate the minimum value of the resistance \( R_s \) so that the zener diode will not burn when the input voltage is \( V_{in}=10\,\text{V} \). 
A piece of granite floats at the interface of mercury and water. If the densities of granite, water and mercury are \( \rho, \rho_1, \rho_2 \) respectively, the ratio of volume of granite in water to that in mercury is 
One end of a steel wire is fixed to the ceiling of an elevator moving up with an acceleration \( 2\,\text{m/s}^2 \) and a load of \( 10\,\text{kg} \) hangs from the other end. If the cross-section of the wire is \( 2\,\text{cm}^2 \), then the longitudinal strain in the wire is given. (Take \( g=10\,\text{m/s}^2 \) and \( Y=2.0\times10^{11}\,\text{N/m}^2 \)). 
The potential of a point is defined as the work done per unit charge that results in bringing a charge from infinity to a certain point.
Some major things that we should know about electric potential:
The ability of a capacitor of holding the energy in form of an electric charge is defined as capacitance. Similarly, we can also say that capacitance is the storing ability of capacitors, and the unit in which they are measured is “farads”.
Read More: Electrostatic Potential and Capacitance
Both the Capacitors C1 and C2 can easily get connected in series. When the capacitors are connected in series then the total capacitance that is Ctotal is less than any one of the capacitor’s capacitance.
Both Capacitor C1 and C2 are connected in parallel. When the capacitors are connected parallelly then the total capacitance that is Ctotal is any one of the capacitor’s capacitance.