Question:
In which polymer preparation, Ziegler–Natta catalyst is used?
In which polymer preparation, Ziegler–Natta catalyst is used?
Show Hint
Ziegler–Natta catalysts are mainly used in the production of HDPE and polypropylene.
Updated On: Jun 4, 2025
- Low density polythene
- Teflon
- Polyacrylonitrile
- High density polythene
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
Ziegler–Natta catalysts are used for the polymerization of ethene to form high density polythene (HDPE). These catalysts enable polymerization under milder conditions and provide better control over the polymer structure.
Was this answer helpful?
0
0
Top Questions on Polymers
- (i) Give any three uses of silicones.
(ii) Write a short note on Fischer-Tropsch synthesis. - How is terylene prepared?
- Write the name of catalyst used in preparation of HDP.
- Draw structure of isoprene unit of natural rubber.
- Write a reaction for preparation of Nylon-6.
View More Questions
Questions Asked in AP EAPCET exam
- The voltage gains of two amplifiers connected in series are 8 and 12.5. If the voltage of the input signal is 200 \(\mu V\), then the voltage of the output signal is
- AP EAPCET - 2025
- Transistors
- If a straight current-carrying wire of linear density $0.12~\text{kg/m$ is suspended in mid-air by a uniform horizontal magnetic field of $0.5~\text{T}$ normal to the length of the wire, then the current through the wire is (Neglect earth’s magnetic field)}
- AP EAPCET - 2025
- Magnetism and matter
- The equations for the displacements of two particles in simple harmonic motion are \( y_1 = 0.1\sin\left(100\pi t + \frac{\pi}{3}\right) \) and \( y_2 = 0.1\cos(\pi t) \) respectively. The phase difference between the velocities of the two particles at a time \( t = 0 \) is
- AP EAPCET - 2025
- Waves and Oscillations
- If the velocity at the maximum height of a projectile projected at an angle of \(45^\circ\) is \(20 \, \text{m/s}\), then the maximum height reached by the projectile is:
- AP EAPCET - 2025
- Rotational motion
- Steam at \( 100^\circ \)C is passed into \( 114 \) g of water at \( 30^\circ \)C. The mass of water present in the mixture when the temperature of the water becomes \( 70^\circ \)C is:
- AP EAPCET - 2025
- Thermodynamics
View More Questions