Question:
An amplifier with proper negative feedback network circuits:
An amplifier with proper negative feedback network circuits:
Show Hint
Feedback in amplifiers can be positive or negative. Negative feedback stabilizes the gain, while positive feedback increases the amplification.
Updated On: Apr 28, 2026
- Converts alternating current into direct current
- An amplifier with no feedback network
- Converts direct current into alternating current
- An amplifier with proper positive feedback network circuits
Show Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
Step 1: Understanding feedback in amplifiers
In amplifier circuits, feedback is the process of feeding a portion of the output signal back to the input. Feedback can be of two types: positive feedback and negative feedback.
Step 2: Effect of negative feedback
Negative feedback reduces gain but improves stability, linearity, bandwidth, and reduces distortion. Therefore, it is widely used in practical amplifiers.
Step 3: Effect of positive feedback
Positive feedback increases the effective gain but makes the system unstable. It is not used for stable amplification; instead, it is mainly used in oscillators to generate sustained signals.
Final Conclusion:
Thus, amplifiers for proper and stable operation use negative feedback networks, not positive feedback.
In amplifier circuits, feedback is the process of feeding a portion of the output signal back to the input. Feedback can be of two types: positive feedback and negative feedback.
Step 2: Effect of negative feedback
Negative feedback reduces gain but improves stability, linearity, bandwidth, and reduces distortion. Therefore, it is widely used in practical amplifiers.
Step 3: Effect of positive feedback
Positive feedback increases the effective gain but makes the system unstable. It is not used for stable amplification; instead, it is mainly used in oscillators to generate sustained signals.
Final Conclusion:
Thus, amplifiers for proper and stable operation use negative feedback networks, not positive feedback.
Was this answer helpful?
0
0
Top VITEEE Physics Questions
- A motor of power $P_0$ is used to deliver water at a certain rate through a given horizontal pipe. To increase the rate of flow of water through the same pipe $n$ times, the power of the motor is increased to $P_1$. The ratio of $P_1 $ to $P_0$ is
- A $30\,V-90\,W$ lamp is operated on a $120\,V$ DC line. A resistor is connected in series with the lamp in order to glow it properly. The value of resistance is
- The masses of three copper wires are in the ratio $2 : 3 : 5$ and their lengths are in the ratio $5 : 3 : 2$ .Then, the ratio of their electrical resistances is
- A soap bubble of radius $r$ is blown up to form a bubble of radius $2 r$ under isothermal conditions. If $T$ is the surface tension of soap solution, the energy spent in the blowing
- A large number of liquid drops each of radius r coalesce to from a single drop of radius R. The energy released in the process is converted into kinetic energy of the big drop so formed. The speed of the big drop is (given, surface tension of liquid T, density $\rho$)
View More Questions
Top VITEEE communication systems Questions
- Sky wave propagation is used in
- The frequency of an $FM$ transmitter without signal input is called
- The attenuation in optical fibre is mainly due to
- Sinusoidal carrier voltage of frequency $1.5\, MHz$ and amplitude $50\, V$ is amplitude modulated by sinusoidal voltage of frequency $10\, kHz$ producing $50 \%$ modulation. The lower and upper side-band frequencies in $kHz$ are
- In amplitude modulation, the amplitude of carrier wave is $A_c$ and that of the modulating signal is $A_m$. In practice, the ratio of to $A_m$ to $A_c$ is kept less than or equal to one, to avoid
View More Questions
Top VITEEE Questions
- A motor of power $P_0$ is used to deliver water at a certain rate through a given horizontal pipe. To increase the rate of flow of water through the same pipe $n$ times, the power of the motor is increased to $P_1$. The ratio of $P_1 $ to $P_0$ is
- A $30\,V-90\,W$ lamp is operated on a $120\,V$ DC line. A resistor is connected in series with the lamp in order to glow it properly. The value of resistance is
- Which of the following is not a characteristic of transition elements ?
- Most crystals show good cleavage because their atoms, ions or molecules are
- Which of the following sets consists only of essential amino acids ?
View More Questions