Question:
A phase lag compensation will ________.
A phase lag compensation will ________.
Show Hint
Phase lag compensation improves steady-state accuracy but reduces bandwidth and response speed. Don’t confuse with lead compensation.
Updated On: Jun 23, 2025
- improve relative stability
- increase the speed of response
- increase bandwidth
- increase overshoot
Show Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
Actually, Phase lag compensation reduces bandwidth and improves steady-state accuracy, but slows down system response.
Hence, the correct effect is improves steady-state performance, not speed.
Hence, the correct effect is improves steady-state performance, not speed.
Was this answer helpful?
0
0
Top AP PGECET Electronics and Communication Engineering Questions
- Identify the Y equivalent of a network of the circuit shown in Figure below.
- The mesh current method
(I) Works with both planar and non-planar circuits
(II) Uses Kirchhoff’s voltage law
Which of the above is correct? - If there are 5 branches and 4 nodes in the graph, then the number of mesh equations that can be formed are?
- The current waveform \(i(t)\) in a pure resistor of 20 \( \Omega \) is as shown in the figure below, then the power dissipated in the resistor is
- In the following figure, \(C_1\) and \(C_2\) are ideal capacitors. \(C_1\) has been charged to 12V before the ideal switch \(S\) is closed at \(t = 0\). The current \(i(t)\) for all \(t\) is
View More Questions
Top AP PGECET Electronics Questions
- The medium which reflects high frequency radio waves back to the earth’s surface is called _______.
- The maximum power efficiency of an AM modulator is _______.
- In a simple RC high-pass filter, the desired roll-off frequency is 15 Hz and \(C = 10\ \mu F\). The value of \(R\) would be _______.
- Determine the continuous time convolution integral and choose correct option for:
\(y(t) = [u(t) - u(t - 2)] * u(t)\) - The energy of a signal \(A\delta[n]\) is _______.
View More Questions
Top AP PGECET Questions
- If 125V is applied across a 250V, 100W incandescent bulb, the power consumed will be _____ .
- The power consumed by a coil is 300 watts when connected to a 30V DC source and 108 watts when connected to a 30V AC source. The reactance of the coil is ____ .
The supply voltage magnitude \( |V| \) of the circuit shown below is ____ .
A two-port network is defined by the relation
\(\text{I}_1 = 5V_1 + 3V_2 \)
\(\text{I}_2 = 2V_1 - 7V_2 \)
The value of \( Z_{12} \) is:- Which of the following theorems is the dual of Norton’s theorem?
View More Questions