List of top Physics Questions asked in NEET (UG)

A thermodynamic system is taken through the cycle abcda. The work done by the gas along the path bc is :

A bob is whirled in a horizontal plane by means of a string with an initial speed of ω rpm. The tension in the string is T. If speed becomes 2ω while keeping the same radius, the tension in the string becomes:

The graph which shows the variation of \(\big(\frac{1}{\lambda^2} \big)\)and its kinetic energy, is \(E\) (where \(λ\) is de Broglie wavelength of a free particle):

In an ideal transformer, the turns ratio is \(N_p/N_s\) =1/2 .The ratio \(V_S:V_P\) is equal to (the symbols carry their usual meaning):

A tightly wound \(100\) turns coil of radius \(10 cm\) carries a current of \( 7 A\). The magnitude of the magnetic field at the centre of the coil is (Take permeability of free space as \(4\pi×10^{-7}\) SI units):

A horizontal force 10 N is applied to a block 4 as shown in figure. The mass of blocks A and B are 2 kg and 3 kg, respectively. The blocks slide over a frictionless surface. The force exerted by block A on block B is:

A wire of length and resistance \(100\) is divided into 10 equal parts. The first \(5\) parts are connected in series while the next \(5\) parts are connected in parallel. The two combinations are again connected in series. The resistance of this final combination is:

The terminal voltage of the battery, whose emf is\(10V\) and internal resistance\(1Ω\), when connected through an external resistance of \(4Ω\) as shown in the figure is:

A logic circuit provides the output y as per the following truth table:

A	B	Y
0	0	1
0	1	0
1	0	1
1	1	0

The expression for the output Y is:

In a Vernier caliper, \(N+1\) divisions of vernier scale coincide with \(N\) divisions of main scale. If 1 MSD represents 0.1 mm, the vernier constant (in cm) is:

In a series LCR circuit, the inductance L is 10 mH, Capacitance C is 1μF and resistance R is 100Ω. The frequency at which resonance occurs is

A bullet is fired from a gun at the speed of 280 ms^-1 in the direction 30° above the horizontal. The maximum height attained by the bullet is
(g = 9.8 ms^-2, sin 30° = 0.5)

Calculate the maximum acceleration of a moving car so that a body lying on the floor of the car remains stationary. The coefficient of static friction between the body and the floor is 0.15 (g=10ms^-2).

The work functions of Caesium (Cs), Potassium (K) and Sodium (Na) are 2.14eV, 2.30 eV and 2.75eV respectively. If incident electromagnetic radiation has an incident energy of 2.20eV, which of these photosensitive surfaces may emit photoelectrons?

A vehicle travels half the distance with speed θ and the remaining distance with speed 2θ. its average speed is

A football player is moving southward and suddenly turns eastward with the same speed to avoid an opponent. The force that acts on the player while turning is:

If the galvanometer G does not show any deflection in the circuit shown, the value of R is given by: