List of top Metallurgical Engineering Questions asked in TS PGECET

In two high reversing mill, the rolls used are
Forging is accomplished in drop forging by dropping the
The microsegregation observed in casting is called
Which of the following has the lowest tensile strength?
Which of the following assumptions is not related to continuous casting?
The objection with the use of ------------- is a tendency for producing a fountain effect in the casting.
The most serious manufacturing defect from fracture toughness point of view is
Strain ageing is common in
Which of the following occupy maximum percentage of powder metallurgy parts distribution in the engineering industry?
Stretcher strains found in a low carbon sheet are associated with
The primary strengthening mechanism in 70:30 brass is
Frank–Read source
Movement of jogs can produce
The tensile load-elongation curve of a metal does not describe
Von Mises criterion for plastic yielding of a ductile material predicts that the yield stress in uniaxial tension is related to that in pure torsion as
Stress intensity factor, \( K_{\text{IC}} \), not depends on
The elastic strain energy of a unit length of an edge dislocation as compared to that of a screw dislocation is
The yield point phenomenon observed in annealed low carbon steel is due to the presence of the following element
The Vicker’s diamond pyramid method of hardness determination does not give accurate result, when employed for the
The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is
Which of the following mechanical properties of a material is most structure insensitive?
Decrease in stress at constant deformation under creep conditions is termed as the
Creep resistance can be improved by allowing the
The value of Poisson’s ratio of most of the metals is
Extensive plastic deformation occurs during