List of top Questions asked in TS PGECET

Pressure inside the casing of an impulse turbine is
What type of dam is constructed using the hydraulic fill method?
The ratio of the weight of water consumed from various sources by a plant in order to produce one unit weight of plant above the root zone is called
The technical term used to relate the volume of water and the area of crop it matures is
Flow over a spillway of a dam is to be treated as
What is the value of the included angle between two adjacent sides of the absolute best hydraulic trapezoidal open channel?
What is the non-dimensional number that results when the ratio of inertia force to gravity force is considered?
The type of flow, if \(\dfrac{\partial v}{\partial s}=0\), is
The failure of the bottom of a deep excavation in sand due to the lowering of the water level inside relative to the outside is due to the phenomenon of
Quick sand condition occurs when
When a retaining wall moves away from the backfill, the pressure exerted on the wall is termed as
The critical hydraulic gradient \(i_c\) for a soil with a grain specific gravity \(G\) and a void ratio \(e\) is given by
During CBR test, the load sustained by a re-moulded soil specimen at \(5\,\mathrm{mm}\) penetration is \(50\,\mathrm{kg}\). The CBR value of the soil will be
The earth pressure distribution on braced sheeting is based on
The best method for compaction of cohesion-less soils is
A clay deposit suffers a total settlement of \(4\,\mathrm{cm}\) with one-way drainage. With two-way drainage, it suffers a total settlement of
The shear strength for a structural clay from the unconfined compression test is
A plate used for connecting two or more steel members is called
Which one of the following is categorized as a long-term loss of pre-stress in a pre-stressed concrete member?
High strength/high grade concrete is preferred for pre-stressed concrete for controlling
Textural classifications are merely based on
Compressibility of a field deposit is
The pore water pressure in the capillary zone is
As per IS 456:2000, the maximum spacing of vertical stirrups is to be limited to
Which section is good from ductility point of view?