List of top Questions asked in TANCET

Increasing a proportional gain will:
Which of the following is not a component of a starter motor?
Why slip rings in an alternator are necessary?
Piston crevice volume is one of the reasons for ___________ emission:
Which of the following sensors is usually installed in the exhaust manifold?
In a wind tunnel, the honeycomb has a longer length that reduces the ______ velocity components of the flow with minimal pressure drop in the stream wise direction.
Solar radiation is increased inside the passenger compartment by increasing __________ of a car.
Which of the following is the longitudinal framing of the roof at the joining?
Consider the following statements about theory of simple bending:
(i) Beam material is isotropic and homogeneous
(ii) Elastic modulus of beam material is more in tension than in compression
(iii) Radius of curvature is large Of these statements,
The negative plates of a lead acid battery have
In a modern final drive, the type of gearing used for the drive pinion and ring gear is:
Which type of rear axle is used in heavy vehicles?
What is the maximum power transmitted by a single plate clutch at speed of 3600 rev/min if the coefficient of friction is 0.4 and the linings have a radius of 160mm inner and 190mm outer? The total spring force is 2.5 kN.
Transfer case is used in a:
The rolling resistance does not depend upon
Outer part of the tyre that extends from the bead to the tread is
What is gear ratio of second year if Gear ratio of first and third gears are 4 and 1.55?
The following diverts the power at right angles towards the driving wheels:
What is the angle between the steering axis and the vertical when viewed from the side of the vehicle?
Match list I with list II and select the correct answer using the code given:
Interpolations
Wheel alignment servicing equipment is used to measure:
Match list I with list II and select the correct answer using the code given:
Quick return mechanism
In which of the following welding methods is the Heat affected zone (HAZ) minimum?
In a fluid coupling, power is transferred due to:
When there is a reduction in amplitude over every cycle of vibration, then the body is said to have