List of top Questions asked in TANCET- 2024

The limiting value of cant excess for Broad Gauge is
The 18-8 stainless steel indicates the one of the following compositions
How many elastic constants will be in a non-homogeneous, non-isotropic material?
The ductility value of bitumen for suitability in road construction should not be less than
The ratio of the total volume of water delivered to a crop to the area on which it has been spread is called:
The most desirable alignment of an irrigation canal is along:
In the preservation process of timber, the surface is burnt and the burnt part acts as a protective coating is named as

As per IS800-2007, the minimum centre-to-centre bolt spacing measured in the direction of stress is ……. , where \( d \) is the nominal diameter of bolt.

The net section strength of a tension member …………. with the increase in ductility of steel.

As per IS 800 : 2007, the maximum deflection in a beam shall not exceed
Intermediate vertical stiffeners are provided in plate girders to prevent
If two foundations, one narrow and another wide, are resting on a bed of sand carrying the same intensity of load per unit area, then which one is likely to fail early?
A square plate of section 30 cm \(\times\) 30 cm and length 10 m penetrates a deposit of clay having \( C = 5 \) kN/m\(^2\) and the mobilizing factor \( m = 0.8 \). What is the load carried by the pile by skin friction only?
If cross slope of a country is greater than 60\%, the terrain is classified as
The Standard percentile value taken for fixing the variability of human characteristics is
In Instrumental Landing System, the middle markers are located
Ozone is formed in the upper atmosphere by a photochemical reaction with:
As compared to uniaxial tension or compression, the strain energy stored in bending is only
In a simply supported beam \( (l + 2a) \) with equal overhangs \( (a) \) and carrying a uniformly distributed load over its entire length, B.M. at the middle point of the beam will be zero if
The ratio of the maximum deflections of a beam simply supported at its ends with an isolated central load and that of with a uniformly distributed load over its entire length, is
A thin cylindrical shell of diameter \( d \) and thickness \( t \) is subjected to an internal pressure \( p \). The ratio of longitudinal strain to volumetric strain is

The degree of static indeterminacy for the frame shown in the figure is 

The shape of the influence line diagram for horizontal thrust in a symmetrical three-hinged parabolic arch is
The vertical deflection at the free end of a quadrantal ring (Radius \( R \) with uniform flexural rigidity \( EI \)) which is fixed at the base and subjected to a vertically downward load \( W \) at the free end is
A scratch is made on the surface of the brick. In a good brick, no impression will be left on the surface. This process of testing of bricks is called as