Question:
The temperature at which the solubility of the surfactant is equal to the CMC, is called as
The temperature at which the solubility of the surfactant is equal to the CMC, is called as
Updated On: Feb 24, 2026
Critical micellar concentration
- Kraft point
- Cloud point
- Solubilization
Show Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
The question asks for the term used to describe the temperature at which the solubility of a surfactant equals its critical micelle concentration (CMC). Let's analyze the options provided:
- Critical micellar concentration (CMC): This is the concentration of surfactants above which micelles form and all additional surfactants added to the system form micelles. It is a concentration term, not a temperature.
- Kraft point: This is indeed the correct term. The Kraft point is the temperature at which the solubility of a surfactant in water is equal to its CMC. Below this temperature, surfactants typically exist in an insoluble crystalline form, while above it, they dissolve to form micelles.
- Cloud point: This term is used for nonionic surfactants, and it refers to the temperature at which a solution becomes cloudy due to phase separation. It is different from the Kraft point.
- Solubilization: This is a process where a solute (e.g., oil) is dissolved into the micelles of a surfactant in a solvent (usually water). It is not directly related to temperature and solubility relation as described in the question.
Based on the explanations, the correct answer is the Kraft point. It specifies the exact condition of temperature where the surfactant achieves solubility equivalent to its critical micelle concentration, allowing micelle formation to occur freely.
Was this answer helpful?
0
0
Top GPAT Physical Chemistry Questions
- Stability index, determined for evaluating the stability of oil–water viscous emulsions, based on electric conductivity changes during non‐destructive short heating–cooling–heating cycles,
A. is defined as \(\frac{Δ}{h}\), where h is the change in the conductivity between 35°C and 45°C and Δ is the conductivity interval within the two heating curves at 35°C
B. indicates the relative change in enthalpy between two cycles
C. is defined as \(\frac{2Δ}{h}\), where h is the change in the conductivity between 35°C and 45°C and Δ is the conductivity interval within the two heating curves at 35°C
D. indicates the relative change in conductivity between two cycles
Choose the correct answer from the options given below: - Which one of the following is a rate equation for second order bimolecular reaction if, a and b are the initial concentrations of A and B, respectively, and x is the concentration of each species reacting in time t and k is second‐order reaction
- Dynamic Vapour Sorption (DVS) isotherm is a plot of A versus B
- Which is NOT the colligative property?
(A)Depression of freezing point
(B) Elevation of boiling point
(C)Elevation of vapour pressure
(D) Osmotic pressure
Choose the correct one of the following: - The value of R in energy of activation is
View More Questions
Top GPAT Solutions Questions
- The properties of solutions containing surface active agents change sharply over a narrow concentration range and are called as
- Burow's solution is:
- When 50 ml of sodium hydroxide (0.1 M) is added to 100 mL of 0.1 M acetic acid, pH of the resultant solution is ___
Ka of acetic acid =\(1.82\times10^{-5}\) - Dakin's solution is a synonym for :
- In Universal indicators, a pH of 7 is shown with:-
View More Questions
Top GPAT Questions
- Match the symbols in the List I with the terms used in the List II of conductance measurements, and
List I
SymbolsList II
TermsA \(\Omega^{-1}\) I Specific conductance B \(∧\) II Electrical conductance C k III Specific resistance D \(\rho\) IV Equivalent conductance
Choose the correct answer from the options given below: - Cottrell’s method is used for the measurement of:
- Match the statements in List I with their correct answers in List II, respectively, in respect to modified 1st law of thermodynamics, and
List I
List II
A Constant heat (q = 0) I Isothermal B Reversible process at constant temperature (dT = 0) II Isometric C Constant volume (dV = 0) III Adiabatic D Constant pressure (dP = 0) IV Isobar
Choose the correct answer from the options given below: - Boric acid with molecular weight 61.83 was partitioned between water and amyl alcohol at 25 °C. The amount of boric acid was determined to be 0.24 g in 250 ml of amyl alcohol and 0.32 g in 100 ml water. The partition coefficient of boric acid between water and amyl alcohol, when calculated at molar concentration for each of the solution, is:
- Drugs ‘A’, ‘B’ and ‘C’ follow zero order, first order and second order degradation kinetics, respectively, but have the same rate constant. Which of the following statement is true in this respect:
View More Questions