Question:
The ordinates of a 1-hour unit hydrograph (UH) are given below.Time (hours) 0 1 2 3 4 5 6 7 8 9 10 11 Ordinates of 1-hour UH (m3/s) 0 13 50 80 95 85 55 35 15 10 3 0
These ordinates are used to derive a 3-hour UH. The peak discharge (in m3/s) for the derived 3-hour UH is _____ (rounded off to the nearest integer).
The ordinates of a 1-hour unit hydrograph (UH) are given below.
These ordinates are used to derive a 3-hour UH. The peak discharge (in m3/s) for the derived 3-hour UH is _____ (rounded off to the nearest integer).
| Time (hours) | 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Ordinates of 1-hour UH (m3/s) | 0 | 13 | 50 | 80 | 95 | 85 | 55 | 35 | 15 | 10 | 3 | 0 |
Updated On: Feb 3, 2026
Show Solution
Verified By Collegedunia
Correct Answer: 86
Solution and Explanation
The answer is: 86 or 88 (approx.)
Was this answer helpful?
0
0
Top GATE CE Water Resources Engineering Questions
- Is this incompressible or irrotational?
\(V = 3î + 5 xĴ\) - A 30 cm diameter well fully penetrates an unconfined aquifer of saturated thickness 20 m with hydraulic conductivity of 10 m/day. Under the steady pumping rate for a long time, the drawdowns in two observation wells located at 10 m and 100 m from the pumping well are 5 m and 1 m, respectively. The corresponding pumping rate (in m3/day) from the well is _____ . (rounded off to 2 decimal places)
- A flow velocity field \(\vec V:\vec V(x, y)\) for a fluid is represented by
\(\vec V = 3\hat i+ (5x)\hat j\)
In the context of the fluid and the flow, which one of the following statements is CORRECT? - For assessing the compliance with the emissions standards of incineration plants, a correction needs to be applied to the measured concentrations of air pollutants. The emission standard (based on 11% Oxygen) for HCl is 50 mg/Nm3 and the measured concentrations of HCl and Oxygen in flue gas are 42 mg/Nm3 and 13%, respectively.
Assuming 21% Oxygen in air, the CORRECT statement is: - A 2m × 2m tank of 3 m height has inflow, outflow and stirring mechanisms. Initially, the tank was half-filled with fresh water. At t = 0, an inflow of a salt solution of concentration 5 g/m3 at the rate of 2 litre/s and an outflow of the well stirred mixture at the rate of 1 litre/s are initiated. This process can be modelled using the following differential equation:
\(\frac {dm}{dt}+\frac {m}{6000+t}=0.01\)
where m is the mass (grams) of the salt at time t (seconds). The mass of the salt (in grams) in the tank at 75% of its capacity is _____ (rounded off to 2 decimal places).
View More Questions
Top GATE CE Questions
- If \(1+\frac{1}{2}+\frac{1}{3}+\frac{1}{4}+\frac{1}{5}+\frac{1}{6}+\frac{1}{7}+\frac{1}{8}+\frac{1}{9}....\frac{1}{29} =\frac{N}{29!}\) Find the remainder when N is divided by 19.
- What will be the relative density?
M = 0.5 percentage of air voids
γmin = 1.3 gm/cc
γmax = 1.8 gm/cc - Find RL of R?
RL of P [BM = 200.000Point Staff Readings
Back sideStaff Readings
Fore sideRemarks P -2.050 - 200.000 Q 1.050 0.95 Change Point R - -1.655 - - What will the angle of the failure plane from horizontal for sand be?
σ3=300
σ1=300+100=400 - Which of the following having negative skamptam Pore water coefficient?
View More Questions