Question:
A 2m × 2m tank of 3 m height has inflow, outflow and stirring mechanisms. Initially, the tank was half-filled with fresh water. At t = 0, an inflow of a salt solution of concentration 5 g/m3 at the rate of 2 litre/s and an outflow of the well stirred mixture at the rate of 1 litre/s are initiated. This process can be modelled using the following differential equation:
\(\frac {dm}{dt}+\frac {m}{6000+t}=0.01\)
where m is the mass (grams) of the salt at time t (seconds). The mass of the salt (in grams) in the tank at 75% of its capacity is _____ (rounded off to 2 decimal places).
A 2m × 2m tank of 3 m height has inflow, outflow and stirring mechanisms. Initially, the tank was half-filled with fresh water. At t = 0, an inflow of a salt solution of concentration 5 g/m3 at the rate of 2 litre/s and an outflow of the well stirred mixture at the rate of 1 litre/s are initiated. This process can be modelled using the following differential equation:
\(\frac {dm}{dt}+\frac {m}{6000+t}=0.01\)
where m is the mass (grams) of the salt at time t (seconds). The mass of the salt (in grams) in the tank at 75% of its capacity is _____ (rounded off to 2 decimal places).
\(\frac {dm}{dt}+\frac {m}{6000+t}=0.01\)
where m is the mass (grams) of the salt at time t (seconds). The mass of the salt (in grams) in the tank at 75% of its capacity is _____ (rounded off to 2 decimal places).
Updated On: Feb 3, 2026
Show Solution
Verified By Collegedunia
Correct Answer: 24.5
Solution and Explanation
The answer is: 24.50 or 25.50 (approx.)
Was this answer helpful?
0
1
Top GATE CE Water Resources Engineering Questions
- If the weights retained on the 2.36 mm, 1.18 mm, 600 $\mu m$, and 300 $\mu m$ sieves are 30%, 35%, 15%, and 20%, respectively, of the total weight of an aggregate sample, then the fineness modulus of the sample is ........... (rounded off to 2 decimal places).
- GATE CE - 2025
- Water Resources Engineering
- Hydrograph analysis
A steel beam supported by three parallel pin-jointed steel rods is shown in the figure. The moment of inertia of the beam is \( 8 \times 10^7 \, {mm}^4 \). Take modulus of elasticity of steel as 210 GPa. The beam is subjected to uniformly distributed load of 6.25 kN/m, including its self-weight. The axial force (in kN) in the centre rod CD is ......... (round off to one decimal place).
- GATE CE - 2025
- Water Resources Engineering
- Hydrograph analysis
Consider the frame shown in the figure under the loading of 100 kN.m couples at the joints B and G. Considering only the effects of flexural deformations, which of the following statements is/are true:
- GATE CE - 2025
- Water Resources Engineering
- Hydrograph analysis
- A water resources project with an expected life of 25 years has to be designed for an acceptable risk of 5% against a design flood. The return period for the design flood (in years) is ........... (rounded off to the nearest integer).
- GATE CE - 2025
- Water Resources Engineering
- Ground water hydrology
The mean rainfall over a catchment has to be estimated. The data for four rain gauges located in and around the catchment is listed in the table. Which one of the following statements is correct:
- GATE CE - 2025
- Water Resources Engineering
- Flood estimation and routing
View More Questions
Top GATE CE Properties of Fluids Questions
- A lake has a maximum depth of 60 m. If the mean atmospheric pressure in the lake region is 91 kPa and the unit weight of the lake water is 9790 N/m\(^3\), the absolute pressure (in kPa, round off to two decimal places) at the maximum depth of the lake is \(\underline{\hspace{2cm}}\).
- GATE CE - 2021
- Water Resources Engineering
- Properties of Fluids
- A fire hose nozzle directs a steady stream of water of velocity 50 m/s at an angle of 45° above the horizontal. The stream rises initially but then eventually falls to the ground. Assume water as incompressible and inviscid. Consider the density of air and the air friction as negligible, and assume the acceleration due to gravity as 9.81 m/s\(^2\). The maximum height (in m, round off to two decimal places) reached by the stream above the hose nozzle will then be \(\underline{\hspace{1cm}}\).
- GATE CE - 2021
- Water Resources Engineering
- Properties of Fluids
- Is this incompressible or irrotational?
\(V = 3î + 5 xĴ\)- GATE CE
- Water Resources Engineering
- Properties of Fluids
Top GATE CE Questions
- A bridge has an expected design life of 50 years. It is designed for a flood discharge of 1000 m\(^3\)/s, which corresponds to a return period of 100 years. Determine the risk (probability) that the design flood will be equalled or exceeded at least once during the design life of the bridge. (Enter the numerical value of risk in decimal form, correct up to three decimal places.)
- GATE CE - 2026
- Hydrograph
- A function f(x) is defined on the interval with values in R. It satisfies \( \int_0^2 f(x)[x-f(x)]dx = \frac{2}{3} \). Find the value of f(1).}
- GATE CE - 2026
- Calculus
- Consider the matrix \( A = \begin{pmatrix} 9 & 15 \\ 15 & 50 \end{pmatrix} \). The matrix A is decomposed using Cholesky decomposition. Determine the value of \(l_{22}\).
- GATE CE - 2026
- Linear Algebra
- Bag-I contains 4 white and 6 black balls, Bag-II contains 4 white and 3 black balls. A ball is selected at random and it comes out to be a black ball. What is the probability that it is from Bag-I?
- GATE CE - 2026
- Probability and Statistics
- Given the following data: x: (-2, 1, 2), y: (28, 4, 16). Let \(P_2(x)\) be the quadratic interpolating polynomial passing through the above three points. Find the value of \(P_2(0)\).
- GATE CE - 2026
- Numerical Methods
View More Questions