Question:
Independent angles AOB, BOC and AOC were observed as shown in figure. The standard error of all observations is same. The adjusted values of these angles using the least squares adjustment are
Independent angles AOB, BOC and AOC were observed as shown in figure. The standard error of all observations is same. The adjusted values of these angles using the least squares adjustment are
Updated On: Jan 31, 2026
- AOB = 30°00′15′′, BOC = 30°00′00′′, AOC = 60°00′15′′
- AOB 30°00'10", BOC = 30°00'05", AOC = 60°00'15"
- AOB = 30°00'05", BOC = 30°00'10", AOC = 60°00'15"
- AOB 30°00'10", BOC = 30°00'10", AOC = 60°00′20′′
Show Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
The correct answer is (A) : AOB = 30°00′15′′, BOC = 30°00′00′′, AOC = 60°00′15′′
Was this answer helpful?
1
1
Top GATE GE Geomatics Engineering Questions
- The method of least squares is used to:
- GATE GE - 2026
- Geomatics Engineering
- Errors and their adjustment
- Which data model represents geographic features using points, lines, and polygons?
- GATE GE - 2026
- Geomatics Engineering
- Geographic Information System - GIS
A 23 cm square format camera with a focal length of 152.4 mm is used for taking vertical aerial photographs with 60% end-lap. These photographs are viewed under a stereoscope with a base-height ratio of 0.15. The vertical exaggeration while stereoviewing these photographs is ___________ (Answer in integer).}
- GATE GE - 2025
- Geomatics Engineering
- Aerial Photograph
In a map based on the UTM projection, the grid distance is in error with respect to the geodetic distance by about one in four thousand. If the map distance is 3 cm and the map scale is 1:25,000, then the geodetic distance is ___________
A 23 cm square format camera with a focal length of 152.4 mm is used for taking vertical aerial photographs with 60% end-lap. These photographs are viewed under a stereoscope with a base-height ratio of 0.15. The vertical exaggeration while stereoviewing these photographs is ___________ (Answer in integer).
- GATE GE - 2025
- Geomatics Engineering
- Aerial Photograph
View More Questions
Top GATE GE Distance and angle measurement Questions
- The histogram equalization applied to a digital image generally DOES NOT yield a truly uniform histogram of the transformed image due to
- GATE GE - 2024
- Geomatics Engineering
- Distance and angle measurement
- In tangential method of tacheometry, two vanes in a staff were fixed at a distance of 1.0 m with the bottom vane fixed at 1.0 m. The levelling staff was held vertical at a point P and the vertical angles of the vanes observed were 5°30′ and 3°15', respectively. The vertical distance between the instrument axis and the bottom vane would be _______ m (rounded off to two decimal places).
- GATE GE - 2024
- Geomatics Engineering
- Distance and angle measurement
- To reduce the slope distance (S) to an equivalent horizontal distance (H) as shown in the figure given below, the following independent observations were taken.
\(S = 29.95 m ± 0.01 m; \theta = 4°30' ± 10' \)
The required precision of computed horizontal distance is ± 0.005 m. Assume a "balanced accuracy" where the contribution to precision of the horizontal distance comes equally from the slope distance and angle measurements. The minimum number of angle observations to achieve the desired precision is
(Given 1 radian = 206265 seconds)
- GATE GE - 2024
- Geomatics Engineering
- Distance and angle measurement
- In the figure, $ d_1, d_2, d_3$ are three independently measured distances for estimating the unknown distances x and y. The correlation coefficient between the unknown estimates approximately equals to
- GATE GE - 2024
- Geomatics Engineering
- Distance and angle measurement
- An angle is observed independently twice, and the values are as follows:
60°30'10" ± 10"
60°30′20′′ ± 20"
The most probable value (MPV) of the angle is- GATE GE - 2024
- Geomatics Engineering
- Distance and angle measurement
View More Questions
Top GATE GE Questions
- The method of least squares is used to:
- GATE GE - 2026
- Errors and their adjustment
- The angle between true north and magnetic north is called:
- GATE GE - 2026
- Surveying
- In aerial photogrammetry, the scale of a vertical photograph is given by:
- GATE GE - 2026
- Photogrammetry
- Which type of remote sensing system uses its own source of energy?
- GATE GE - 2026
- Remote Sensing
- Which map projection preserves angles and shapes locally?
- GATE GE - 2026
- General Cartography
View More Questions