Question:
The ebullioscopic constant is the elevation in boiling point produced by
The ebullioscopic constant is the elevation in boiling point produced by
Updated On: May 12, 2024
- 1 molar solution
- 1 molal solution
- 1 N solution
- 10% solution.
Show Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
Ebullioscopic constant is the elevation in boiling point when the molality of the solution is unity.
Was this answer helpful?
0
0
Top COMEDK UGET Chemistry Questions
- 0.3 g of an acid is neutralised by 40 $cm^3$ of 0.125 N NaOH. Equivalent mass of the acid is
- Bakelite is manufactured by using a mixture of
- An example for a face centred cubic lattice is
- Coordination number of caesium in caesium chloride is
- Which one of the following is not ferromagnetic?
View More Questions
Top COMEDK UGET Colligative Properties Questions
- The lowering in vapour pressure is maximum for
- Given that the freezing point of benzene is $ 5.48^\circ C $ and its $ K_f $ value is $ 5.12^\circ C/m $, what would be the freezing point of a solution of 20 g of propane in 400 g of benzene?
200 ml of an aqueous solution contains 3.6 g of Glucose and 1.2 g of Urea maintained at a temperature equal to 27$^{\circ}$C. What is the Osmotic pressure of the solution in atmosphere units?
Given Data R = 0.082 L atm K$^{-1}$ mol$^{-1}$
Molecular Formula: Glucose = C$_6$H$_{12}$O$_6$, Urea = NH$_2$CONH$_2$- Which of the following shows negative deviation from Raoult's law?
- 5 g of non-volatile water soluble compound X is dissolved in 100 g of water. The elevation in boiling point is found to be 0.25. The molecular mass of compound X is
View More Questions
Top COMEDK UGET Questions
- If the line px + qy = 0 coincides with one of the lines given by $ax^2 + 2hxy + by^2 = 0$, then
- A long hollow copper pipe carries a current. The magnetic field producted will be
- An ammeter reads 0 to 10 A. It has negligible resistance.To convert this into voltmeter to read upto 250 V, resistance to be used is
- Force of attraction or repulsion between two current carrying wires separated by a distance r is proportional to
- When a material is placed in a magnetic field B, a magnetic moment proportional tc B but in a direction opposite to B is induced. The material is
View More Questions
Concepts Used:
Colligative Properties
Colligative Property of any substance is entirely dependent on the ratio of the number of solute particles to the total number of solvent particles but does not depend on the nature of particles. There are four colligative properties: vapor pressure lowering, boiling point elevation, freezing point depression, and osmotic pressure.
Examples of Colligative Properties
We can notice the colligative properties of arrangements by going through the accompanying examples:
- On the off chance that we add a spot of salt to a glass full of water, its freezing temperature is brought down impressively than its normal temperature. On the other hand, the boiling temperature is likewise increased and the arrangement will have a lower vapor pressure. There are also changes observed in its osmotic pressure.
- In the same way, if we add alcohol to water, the solution’s freezing point goes down below the normal temperature that is usually observed for either pure alcohol or water.
Types of Colligative Properties
- Freezing point depression: ΔTf =1000 x kf x m2 /(M2 x m1)
- Boiling point elevation: ΔTb = kb m
- Osmotic pressure: π = (n2/V) RT
- Relative lowering of vapor pressure: (Po - Ps)/Po