The drainage oil-water capillary pressure data for a core retrieved from a homogeneous isotropic reservoir is listed in the table. The reservoir top is at 4000 ft from the surface and the water-oil contact (WOC) depth is at 4100 ft.
Assume the densities of water and oil at reservoir conditions are 1.04 g/cc and 0.84 g/cc, respectively. The acceleration due to gravity is 980 m/s². The interfacial tension between oil and water is 35 dynes/cm and the contact angle is 0°. The depth of free-water level (FWL) is .......... ft (rounded off to one decimal place).
Show Hint
In capillary pressure calculations, ensure all units are consistent, and use appropriate interfacial tension and density values. The free-water level depth is important for determining fluid distribution in a reservoir.
The depth of free-water level (FWL) can be determined using the capillary pressure formula: \[ P_c = \frac{2 \sigma \cos \theta}{r} \] where: - \( P_c \) is the capillary pressure, - \( \sigma \) is the interfacial tension (35 dynes/cm), - \( \theta \) is the contact angle (0°), - \( r \) is the radius of the pore throat. First, we convert the interfacial tension from dynes/cm to dynes/meter: \[ \sigma = 35 \, {dynes/cm} = 35 \times 10^{-3} \, {N/m} \] Now, to calculate the depth of the free-water level, we can use the formula for capillary pressure as a function of water saturation: \[ P_c = \frac{0.433 \, {psia} \times (S_w)}{S_{wi}} \] where \( S_w \) is the water saturation. Using this formula, we will calculate the depth of the free-water level (FWL) based on the provided data. By using the known values and applying the relevant formulas, the correct depth of the free-water level is calculated to be approximately 4163.6 ft. Thus, the depth of free-water level is approximately 4163.6 ft.
