In the following circuit, the average voltage \[ V_o = 400 \left(1 + \frac{\cos \alpha}{3} \right) {V}, \] where \( \alpha \) is the firing angle. If the power dissipated in the resistor is 64 W, then the closest value of \( \alpha \) in degrees is:

Understanding the Circuit The circuit consists of a three-phase half-wave controlled rectifier feeding an RL load with a battery in series. The average output voltage is given by: \[ V_o = 400 \left(1 + \frac{\cos \alpha}{3} \right) \, {V} \] Given: - Resistor \( R = 1\, \Omega \) - Power dissipated in resistor \( P = 64 \, {W} \) - Battery voltage = 500 V
Step 1: Find average current \[ P = I_{avg}^2 R \Rightarrow 64 = I_{avg}^2 \Rightarrow I_{avg} = \sqrt{64} = 8 \, {A} \] Step 2: Voltage across resistor \[ V_R = I_{avg} \cdot R = 8 \cdot 1 = 8 \, {V} \] Step 3: Find total output voltage \( V_o \) \[ V_o = V_R + {Battery voltage} = 8 + 500 = 508 \, {V} \] Step 4: Plug into average voltage formula \[ 508 = 400 \left(1 + \frac{\cos \alpha}{3} \right) \] \[ \Rightarrow \frac{508}{400} = 1 + \frac{\cos \alpha}{3} \] \[ \Rightarrow 1.27 = 1 + \frac{\cos \alpha}{3} \] \[ \Rightarrow \frac{\cos \alpha}{3} = 0.27 \] \[ \Rightarrow \cos \alpha = 0.81 \] \[ \Rightarrow \alpha = \cos^{-1}(0.81) \approx 35.9^\circ \] \[ \boxed{\alpha \approx 35.9^\circ} \]
Consider a distribution feeder, with \( R/X \) ratio of 5. At the receiving end, a 350 kVA load is connected. The maximum voltage drop will occur from the sending end to the receiving end, when the power factor of the load is: \[ {(round off to three decimal places).} \]
Let \( C \) be a clockwise oriented closed curve in the complex plane defined by \( |z| = 1 \). Further, let \( f(z) = jz \) be a complex function, where \( j = \sqrt{-1} \). Then, \[ \oint_C f(z)\, dz = \underline{{2cm}} \quad {(round off to the nearest integer)}. \]
In an experiment to measure the active power drawn by a single-phase RL Load connected to an AC source through a \(2\,\Omega\) resistor, three voltmeters are connected as shown in the figure below. The voltmeter readings are as follows: \( V_{{Source}} = 200\,{V}, \quad V_R = 9\,{V}, \quad V_{{Load}} = 199\,{V}. \) Assuming perfect resistors and ideal voltmeters, the Load-active power measured in this experiment, in W, is ___________ (round off to one decimal place). 
The steady-state capacitor current of a conventional DC–DC buck converter operating in continuous conduction mode (CCM) is shown over one switching cycle. If the input voltage is \(30\,\text{V}\), the value of the inductor used (in mH) is ____________ (rounded off to one decimal place). 
Consider the state-space model
\[ \dot{\mathbf{x}}(t) = A \mathbf{x}(t) + B r(t), \quad y(t) = C \mathbf{x}(t) \]
where \( \mathbf{x}(t) \), \( r(t) \), and \( y(t) \) are the state, input, and output, respectively. The matrices \( A \), \( B \), and \( C \) are given below:
\[ A = \begin{bmatrix} 0 & 1 \\ -2 & -3 \end{bmatrix}, \quad B = \begin{bmatrix} 0 \\ 1 \end{bmatrix}, \quad C = \begin{bmatrix} 1 & 0 \end{bmatrix} \]
The sum of the magnitudes of the poles is ____________ (round off to the nearest integer).
Given an open-loop transfer function \(GH = \frac{100}{s}(s+100)\) for a unity feedback system with a unit step input \(r(t)=u(t)\), determine the rise time \(t_r\).
Consider a linear time-invariant system represented by the state-space equation: \[ \dot{x} = \begin{bmatrix} a & b -a & 0 \end{bmatrix} x + \begin{bmatrix} 1 0 \end{bmatrix} u \] The closed-loop poles of the system are located at \(-2 \pm j3\). The value of the parameter \(b\) is: