Question:
Gypsum is typically added in cement to:
Gypsum is typically added in cement to:
Show Hint
Gypsum slows down the setting time of cement, giving it more time to mix and pour before it hardens.
Updated On: Jan 2, 2026
- prevent quick setting
- enhance hardening
- increase workability
- decrease heat of hydration
Show Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
Gypsum is added to cement primarily to prevent the cement from setting too quickly, allowing for better workability and handling before it hardens.
Final Answer:
\[
\boxed{\text{A) prevent quick setting}}.
\]
Was this answer helpful?
0
0
Top GATE CE Structural Engineering Questions
- Concrete of characteristic strength 30 MPa is required. If 40 specimens of concrete cubes are to be tested, the minimum number of specimens having at least 30 MPa strength should be
- Consider the statements P and Q.
P: Client's Preliminary Estimate is used for budgeting costs toward the end of planning and design phase.
Q: Client's Detailed Estimate is used for controlling costs during the execution of the project.
Which one of the following options is CORRECT? - The following figure shows the arrangement of formwork for casting a cantilever RC beam.
The correct sequence of removing the Shores/Props is: - The elements that DO NOT increase the strength of structural steel are
- Consider a balanced doubly-reinforced concrete section. If the material and other sectional properties remain unchanged, for which of the following cases will the section becomes under-reinforced?
View More Questions
Top GATE CE Construction Materials Questions
Top GATE CE Questions
- If \(1+\frac{1}{2}+\frac{1}{3}+\frac{1}{4}+\frac{1}{5}+\frac{1}{6}+\frac{1}{7}+\frac{1}{8}+\frac{1}{9}....\frac{1}{29} =\frac{N}{29!}\) Find the remainder when N is divided by 19.
- What will be the relative density?
M = 0.5 percentage of air voids
γmin = 1.3 gm/cc
γmax = 1.8 gm/cc - Find RL of R?
RL of P [BM = 200.000Point Staff Readings
Back sideStaff Readings
Fore sideRemarks P -2.050 - 200.000 Q 1.050 0.95 Change Point R - -1.655 - - What will the angle of the failure plane from horizontal for sand be?
σ3=300
σ1=300+100=400 - Which of the following having negative skamptam Pore water coefficient?
View More Questions