Opening up the solid means laying all its faces flat. Here the central rectangle is the face against the wall, the two identical stepped shapes are the two end faces, and the vertical strips above and below the central rectangle are the faces that run around the stepped outline in order.
The solid is an H-shaped block: a 4-unit tall wall column, a 3-unit wide crossbar layer, a second leg of 1 unit width, a 2-unit deep slot opening at the top and a 1-unit deep slot opening at the bottom.
Walking round the outline from the top of the wall, the lengths of successive faces (in units) are 1, 2, 1, 1, 1 for the strip above the central rectangle. Walking round from the bottom of the wall, the lengths are 1, 1, 1, 1, 1, 3 for the strip below it.
Figure 2 is rejected because its lower strip reads 1, 1, 2, 1, 3; Figure 3 is rejected because its lower strip has six unit pieces and then a 2; Figure 4 is rejected because its upper strip reads 1, 2, 2, 1.
Only answer figure 1 has both strips and both end faces correct.
Answer: (1) answer figure 1