Question:

Directions: Which one of the answer figures shows the correct view of the 3-D problem figure after the problem figure is opened up?

Show Hint

Work out the lengths of the faces around the stepped outline and match them with the strips above and below the central rectangle of each net.
Updated On: Nov 16, 2026
Show Solution
collegedunia
Verified By Collegedunia

The Correct Option is D

Solution and Explanation

Opening up the solid means laying all its faces flat. Here the central rectangle is the face against the wall, the two identical stepped shapes are the two end faces, and the vertical strips above and below the central rectangle are the faces that run around the stepped outline in order.
The solid is a wall (4 units tall) with layers sticking out: the top layer has two 1-unit prongs separated by a 2-unit slot, the second layer is 4 units wide, the third is 2 units wide and the bottom layer is 1 unit wide.
Walking round the outline from the top of the wall, the lengths of successive faces (in units) are 1, 1, 2, 1 for the strip above the central rectangle. Walking round from the bottom of the wall, the lengths are 1, 1, 1, 1, 2, 2, 1 for the strip below it.
Figure 1 is rejected because its lower strip has 2 in the wrong place (1, 1, 1, 1, 2, 1, 1, 1); Figure 2 is rejected because its upper strip is 1, 1, 1, 1, 1 instead of 1, 1, 2, 1; Figure 3 is rejected because its lower strip reads 1, 2, 1, 2, 2, 1.
Only answer figure 4 has both strips and both end faces correct.
Answer: (4) answer figure 4
Was this answer helpful?
0
0