Question:
A copper and a steel wire of same diameter are connected end to end. A deforming force \( F_1 \) is applied to the wire which causes an elongation of 1 cm. The two wires will have
A copper and a steel wire of same diameter are connected end to end. A deforming force \( F_1 \) is applied to the wire which causes an elongation of 1 cm. The two wires will have
Show Hint
Stress depends only on the applied force and the cross-sectional area, while strain depends on the material's Young's modulus.
Updated On: Apr 14, 2025
- the same stress
- different stress
- the same strain
- different strain
Show Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
Stress is defined as the force per unit area, and since the wires have the same diameter, the stress will be the same in both wires. However, strain is defined as the elongation per unit length, and since copper and steel have different Young's moduli, they will have different strains for the same applied force. Therefore, the correct answer is (D).
Was this answer helpful?
0
0
Top COMEDK UGET Physics Questions
- A long hollow copper pipe carries a current. The magnetic field producted will be
- An ammeter reads 0 to 10 A. It has negligible resistance.To convert this into voltmeter to read upto 250 V, resistance to be used is
- Force of attraction or repulsion between two current carrying wires separated by a distance r is proportional to
- When a material is placed in a magnetic field B, a magnetic moment proportional tc B but in a direction opposite to B is induced. The material is
- A moving charge interacts
View More Questions
Top COMEDK UGET mechanical properties of solids Questions
- A crane with.a steel cable of length $ {11 \,m}$ and radius $ {2.0\, cm}$ is employed to lift a block of concrete of mass 40 tons in a building site. If the Young's Modulus of steel is $ {2.0 \times 10^{11} \, Pa}$, what will be roughly the increase in the length of the cable while lifting the block? (Take $ {g = 10\, ms^{-2}}$)
- The dimensions of four wires of the same material are given below. In which wire the increase in length will be maximum when the same tension is applied?
- A force \( F \) applied on the wire of radius \( r \) and length \( L \) and change in the length of the wire is \( l \). If the same force \( F \) is applied on the wire of the same material and radius \( 4r \) and length \( 4L \), then change in length of the other wire is
- Young's modulus of the material of wires X and Y are in the ratio \(4:1\) and the areas of cross sections of the wires X and Y are in the ratio \(2:1\). If the same amount of load is applied to both the wires, the ratio of elongation produced in the wires X and Y will be: (Assume length of the wires X and Y initially are the same)
Top COMEDK UGET Questions
- If the line px + qy = 0 coincides with one of the lines given by $ax^2 + 2hxy + by^2 = 0$, then
- A long hollow copper pipe carries a current. The magnetic field producted will be
- An ammeter reads 0 to 10 A. It has negligible resistance.To convert this into voltmeter to read upto 250 V, resistance to be used is
- Force of attraction or repulsion between two current carrying wires separated by a distance r is proportional to
- When a material is placed in a magnetic field B, a magnetic moment proportional tc B but in a direction opposite to B is induced. The material is
View More Questions